CON35

CON35 in-line actuator

The con35 is a versatile, high efficiency in-line electric actuator with an elegant design and small overall dimensions and a lifting capability of up to 2200 N. The con35 is ideal where size is limited by design or functionality. The in-line electric actuator is made of powder-coated steel with an aluminum or stainless steel piston, and standard IP66, providing a sturdy design that protects the motor and electrics. Compatible controllers, handsets and batteries for mobile use are available.

Properties

  • High efficiency 12/24V DC industrial motor with planetary gear
  • Stroke lengths from 50 to 750 mm
  • Load capacity from 120 to 2200 N
  • Speed at maximum load from 3 to 33 mm/s
  • Front and rear brackets in PA or aluminum, with or without clevis.
  • Stainless steel AISI316 or any RAL color
  • IP66 and 'harsh environment' versions
  • Hall sensors for positioning or synchronization
  • ATEX zone 22, Class II 3 D approval
  • EU/UL/CSA 60.601 certificate
  • Low noise version
  • Eskimo (-40°C to +70°C) version.

Please note

  • Never expose the actuator to hammer strike during installation or in other situations Retrofitted bushings should be pressed into the bracket-borings. No hammering
  • Power supply without over-current protection can cause serious damage to the actuator at mechanical end-stop or when actuator is overloaded in another way
  • Keep piston tube clean
  • Longer cable lengths may cause voltage drop which affects the performance of the actuator
  • For medical applications (IEC/EN/UL60601-1): Operating temperature +5 ̊C to +48 ̊C, Relative humidity 20% – 70% atmospheric pressure = 1atm. Connect to medically approved supply source only and according to guidelines provided with the source
  • Function of the actuator is subject to the settings of the control box
  • The dust and water sealing of Harsh Environment actuators might affect their performance
  • All specifications are for 25 oC ambient – low temperature might affect performance
  • Depending on load and application, nominal and actual stroke length may differ due to internal disc springs not being fully compressed
  • Concens does not have any responsibility for possible errors in this data sheet Specifications are subject to change without notice

Alternatives

CON50

  • Slank en in-line design (diameter 50 mm)
  • Max. 70 mm/sec
  • Max. 4500 N druk/trekkracht
  • Standaard IP66 (optioneel tot IP69)
Delivery time: workdays

CON60

  • Slank en in-line design (diameter 60mm)
  • Max. 26 mm/sec.
  • Max. 10000 N druk/trekkracht
  • Standaard IP66 (optioneel tot IP69)
Delivery time: workdays

Accessories for CON35

C2-10

  • Current limit
  • I-Trip function
  • Two control modes
  • Plug&Play
Delivery time: 5 workdays
Op voorraad

C2-20

  • Soft start-up, acceleration ramp
  • 'Position Reached'-signal
  • Soft start-up, acceleration ramp
  • Trip or continuous current limit
Delivery time: 5 workdays
Op voorraad
© A&E Trading b.v. 2019
Made by Convident